12V 1 Channel Red Color Relay Module

12V 1 Chanel Relay Module With Optical Coupling Isolation Support High And Low Level Trigger .

Introduction:

• 1, this module is in line with international safety standards, the control area and the load area have isolation tank;
• 2, the use of pine music authentic relay;
• 3, with power supply and relay indicator, pull off bright, bright;
• 4, signal input signal, the public side and often start will lead;
• 5, can be used as a microcontroller development board module, can be used as a home appliance control;
• 6, control the DC or AC signals, can control the 220V AC load;
• 7, there is a normally open and a normally closed contact;
• 8, blue KF301 terminal connected to the control line is more convenient.

৳ 69.00

Qty:  Add to Cart

Currently item(s) in cart.

1-8S Lipo Battery Voltage Tester

1-8S Lipo Battery Voltage Tester / Low Voltage Buzzer Alarm.This a great two in one tool that gives a loud alarm at low voltage and can quickly display battery voltage. Simply plug a 1-8s battery's balance connector into the voltage meter/buzzer. You will receive an instant readout of the total voltage and an individual reading of each cell.

৳ 220.00

Qty:  Add to Cart

Currently item(s) in cart.

XL6009 DC Boost ADJ Module

This is a high-performance switching current 4A boost (BOOST) module. The module uses the second generation of high-frequency switching technology XL6009E1 core chip, performance than the first generation technology LM2577. XL6009 boost module at a lower cost, superior performance.

1. Wide input voltage 3V ~ 32V, optimum operating voltage range is 5 ~ 32V;

2. Wide output voltage 5V ~ 35V;

3. Built-4A efficient MOSFET switch, so that the efficiency up to 94%; (LM2577 current is only 3A)

4. Ultra-high switching frequency 400KHz, you can use a small-capacity filter capacitors that can achieve very good results, the ripple is smaller and smaller. (LM2577 frequency only 50KHz)

৳ 90.00

Qty:  Add to Cart

Currently item(s) in cart.

L298N Dual Motor Controller Module

L298N Dual Motor Controller Module 2A and Arduino.

In this tutorial we'll explain how to use our L298N H-bridge   Dual Motor Controller Module 2A with Arduino. This allows you to control the speed and direction of two DC motors, or control one bipolar stepper motor with ease. The L298N H-bridge module can be used with motors that have a voltage of between 5 and 35V DC. 

There is also an onboard 5V regulator, so if your supply voltage is up to 12V you can also source 5V from the board.

These L298 H-bridge dual motor controller modules  are inexpensive and available from the Tronixlabs Australia store. Furthermore if you're completely new to the world of Arduino we highly recommend you  review a copy of "Arduino Workshop", and if you have questions, ask in our customer forum. 

So let's get started!

First we'll run through the connections, then explain how to control DC motors then a stepper motor.

৳ 150.00

Qty:  Add to Cart

Currently item(s) in cart.